Pole-changing motor with a closed fan cowl and the shaft on the drive end

2 or 3 speeds · 0.45–82 kW

YD series motors

Pole-changing multi-speed motors. Speed changes by switching the stator winding, typically with a Dahlander connection. Frames 80–280. Rated voltage 220–690 V.

0.45–82 kWPower
2 or 3Fixed speeds
80–280IEC frame
220–690 VRated voltage
Keyed shaft and foot of a pole-changing motor

The winding sets the speed

Contactors change the connection. Speed stays locked to the supply frequency. The series page uses 4 poles and 8 poles, 1500 rpm and 750 rpm, as the example.

SpeedsPole pairs on the series page
22/4, 4/6, 4/8
32/4/6, 4/6/8

What the series page states

01

No converter in the circuit

The motor is copper and silicon steel. Dual-speed control needs contactors. The series page contrasts that with a stack of converter, shielded cable and filter.

02

No high-frequency harmonics

The series generates no high-frequency harmonics, so it suits laboratory equipment and auxiliary drives on precision machine tools.

03

A stiff speed

Rotational speed stays nearly constant as the load changes. The series page names drill presses and milling machines.

04

Site conditions

Altitude up to 1,000 m. Above that altitude the series page calls for a power derating. Voltage tolerance is ±5%. Class H insulation is available. The housing is described for dust and heavy vibration.

Equipment named on the series page

Machine tools

Cutting, drill presses, milling machines and lathes, where the speed step has to stay put as the load changes.

Fixed high and low

Mixers and conveyors that switch between fixed speeds.

Marine and mining

Winches and drilling machines, where stepped speed is the duty the series page names.

Send the speed steps

Each speed has its own kilowatts. Send the pole pair and the power at every step.

  • Pole pair: 2/4, 4/6, 4/8, 2/4/6 or 4/6/8
  • Kilowatts at each speed
  • Voltage and frequency
  • IEC frame
  • Mounting: B3, B5, B35 or V1. The factory also builds B14, B34, V3 and V5.
Request a quote

Jiangxi Jiawang Special Motor · +86 199 0684 4761 · [email protected]

Before the quote

How does a YD motor change speed?

By changing the internal winding connection, for example from 4 poles to 8 poles. The series page gives 1500 rpm and 750 rpm as that example. An external frequency converter is not part of the circuit.

When is the series the cost comparison against a converter?

When the machine needs 2 or 3 fixed speeds. The series page says that duty removes the converter and holds up where electronics fail.

Where is it used?

Marine, mining and machine tools, including winches, drilling machines and lathes. The opening of the series page also names mixers and conveyors.