IE2 vs IE4 motor
IE2 vs IE4 Industrial Motor Efficiency
IE2 vs IE4 is an energy-class decision, not a different mechanical standard. Both JW Y2 Series (IE2) and YE4 Series (IE4) are IEC metric TEFC industrial motors. The table below is a project filter; efficiency percentages belong on the test report / datasheet, not in marketing copy.
How to read this comparison
IE2
Y2 Series (IE2) — typical when purchase price and simple S1 duty dominate.
IE4
YE4 Series (IE4) — typical when losses, MEPS or long running hours dominate.
Same family of frames
IEC 60072-1 geometry can match; still verify shaft and flange on the datasheet.
IE2 vs IE4
| Dimension | Y2 Series (IE2) | YE4 Series (IE4) |
|---|---|---|
| Efficiency class | IE2 | IE4 |
| Typical project | Cost-first S1 auxiliaries, regions still accepting IE2 | EU/MEPS-driven upgrades, high annual running hours |
| First cost vs losses | Lower purchase price, higher I²R / iron losses | Higher CAPEX, lower losses over life |
| IEC mounting | Metric frames (IEC 60072-1) | Metric frames (IEC 60072-1) |
| Drop-in intent | Replace like-for-like IE2 / older Y | Same H/B/shaft only if kW, poles and shaft match the datasheet |
| VFD / thermal margin | General-purpose TEFC; confirm insulation for inverter use | Still confirm cable length, dv/dt and duty—not automatic inverter-duty |
How to choose
- Choose IE2 when the machine runs few hours per year or the spec still allows that class.
- Choose IE4 when electricity cost or regulation makes the higher class mandatory or clearly cheaper to run.
- Do not skip an intermediate class only because a page exists—many plants correctly stay on IE3 (YE3).
- Lock kW, poles, voltage, mounting code and shaft from the nameplate before treating it as a drop-in.
Do not ignore IE3
IE2 vs IE4 is a two-step jump. Many OEM specs and EU replacements land on IE2 vs IE3 or IE3 vs IE4. Use this page when you are explicitly deciding whether to skip the middle class.
Replacement checklist
- Nameplate kW, Hz, V, poles
- Frame, H, feet or flange, shaft Ø
- Load type: pump, fan, compressor, conveyor
- Direct-on-line vs VFD; cable length if inverter
FAQ
Can I replace an IE2 motor with IE4 in the same frame?
Often the foot-mounting and shaft height follow IEC 60072-1, so the base may not need machining. You still must match rated kW, pole count, shaft diameter and key, voltage, and duty. Confirm the YE4/Y2 datasheet row—not this table—before ordering.
Is IE4 always better than IE2?
No. Higher IE class cuts losses but raises first cost and can change starting current. If the motor is a spare for a lightly loaded auxiliary, IE2 can still be the rational buy. Use IE4 when MEPS, corporate energy policy, or high annual kWh say so.
Where does IE3 fit between these two?
IE3 (YE3) is the usual upgrade from IE2 for general industry. Jumping straight to IE4 makes sense on large, continuously loaded machines or where the specification already names IE4. For most pump/fan S1 duty, compare IE3 vs IE4 as well.
What must I send for a quote?
Rated kW, poles or r/min, voltage and frequency, mounting (B3/B5/B35), existing frame if replacing, and whether a VFD is used. Photos of the nameplate prevent wrong shaft or flange codes.
Get a quote
Request a quote with rated kW, voltage, frequency, pole count, mounting (foot or flange), and whether you need a drop-in IEC replacement or a VFD-rated winding.
Request a quote